|
|
|
|
|
|
|
Check that machine is plugged into wall outletCheckthat power supply is fully connected and LED on power supply is solid greenRemove electronics box and check that all 3 connections are made
|
Power supply LED is off or flashing green
|
|
The power supply has a short circuit or is deadCall Wilson for a new power supply
|
Baiardo is running in the wrong language
|
|
Reset language (see page 5 of the manual)
|
"Manual mode" is displayed at start up
|
|
Check that there is a good connection between bottom and top of machine (2 wires)Remove electronics box and check that all 3 connections are madeIf machine was stored in extreme cold, allow several hours for machine to warm to room temperature
|
Touch screen appears dark/hard to read
|
|
Touch screen to activate backlight. This is an energy saving feature
|
Puller head does not move when activator switch is pressed
|
|
The puller will only activate when the main stringing screen is displayedCheck that the wire on bottom of puller is connected (see page 33 of manual)
|
|
|
|
Move the machine to level surfaceAdjust leveling screws in floor plate
|
String slips through clamp teeth
|
|
Adjust clamp (see page 8 of manual)Clean inner surface of clamp to remove build-up of lubrication from string
|
String slips through puller
|
|
Adjust puller (see page 9 of manual)Clean inner surface of puller to remove build-up of lubrication from string
|
Clamp base slips on glide rail when "locked"
|
|
Adjust clamp base (see page 8)Clean glide railRemove clamp base from glide rail (see page 32 of manual) and clean brass plug that normally sits below glide rail
|
String tension seems lower than normal
|
|
Check that string is not slipping through clampsCalibrate machine (see page 26 of manual)
|
String seems tighter than normal
|
|
Calibrate machine (see page 26 of manual)
|
Clamps leave white marks on string
|
|
This is normal on some multifilament stringsClean and adjust clamps to slightest pressure that still grabs stringBe sure to adjust clampsl for different diameters of string
|
|
|
|
The hex keys are standard metric set and can be puchased at any tool shop
|
|
|
|
The cord form the power brick to the wally is a standard cord used on many electronic devices such as computer, projectors, etc.A replacment can be found at many electronic stores
|
Touch screen glass is cracked or broken and will not work
|
|
The machine can be run from the buttons above and below the touch screen
|
An error code is displayed on the screen
|
|
Turn off the machine, wait several minutes and restartTurn off. Check all connection from base to top (2 wires). Remove ECU box and check all connections (3 wires), replace electronics box and restartCall Wilson. Be sure to have noted the number of the error code
|
|
|
|
|
|
|
|
How to change the Clamp Base on your Baiardo
|
|
|
|
|
|
How to remove/change the Turntable on your Baiardo
|
|
|
|
|
|
How to adjust the Mounting Posts on your Baiardo
|
|
|
|
|
|
How to remove/install the Puller Head on your Baiardo
|
|
|
|
|
|
How to remove/install the Glide Rail(s) on your Baiardo
|
|
|
|
|
|
How to remove/install the Friction Brake on your Baiardo
|
|
|
|
|
|
How to remove/install the Electronics Box on your Baiardo
|
|
|